Table of Contents
Advertisement
2. Basic Management: this section allows to manage some general setting such as light, volume,
and display
I.
Auxiliary light: select Auto to enable automatically emitting auxiliary light in case the
ambient light is dimming; select Customized to specify the time to emit tauxiliary light
II.
Device IP Display: select to show device IP address on screen
III.
Volume control e Brightness control: these commands allow to set the speaker
volume and the display brightness
IV.
Screen Saver mode: set the time to enter screen saver, after some seconds of inactivity.
The range is 0~60 seconds. Set 0 for disable screen saver.
V.
Turn Off Display: set the time to turn off the display, after some seconds of inactivity.
The range is 0~60 seconds. Set 0 for disable the turn off feature
3. Customize: this page shows the commands to upload logo and calibrate temperature:
I.
Logo settings: select Customized to upload a custom logo (.png format), which will be
shown on the lower left corner of display
II.
Temperature calibration: face the FL X1 and click "Start measurement"; the device
takes 3 temperature samples separately and automatically fills in the 3 columns. Fill
the temperature detected by a forehead thermometer in "Forehead Thermometer
Displayed Temp" and finally click Start Calibration to calibrate the temperature.
FL X1 User Manual
18
Advertisement
Table of Contents
