Table of Contents
Advertisement
2.1.2
SUPPORT INSTALLATION
Optionally, it is possible to equip the Olivetti FL X1 with a support to position it on the table or on
the ground.
The available supports are:
1. FS1 Floor Stand (code B3980 000): it is a stand-alone column with the following
characteristics
joint with adjustment of the inclination of the device
rectangular section H 1300 mm, with elliptical bearing base.
epoxy painted metal
2.
DS1 Desk Stand (code B3979 000): with the following characteristics
joint with adjustment of the inclination of the device
rectangular section H 1300 mm, with elliptical bearing base.
epoxy painted metal
The procedure for support mounting is similar to the wall mounting (see previous paragraph),
bcause also the support munting requires the wall bracket supplied with the device:
I.
Release the 2 screws and take out the wall bracket from the device.
II.
Connect the bracket to the appropriate attachment of the support using the provided
screws.
III.
Carefully align and push the main unit into the bracket mounted on the support.
IV.
Align the bracket holes and gently slide it down tightly. After connecting the wires, fix the
bottom cover with screws.
FL X1 User Manual
11
Advertisement
Table of Contents
