Connecting Network; Connect To Pc Directly - Olivetti FL X1 User Manual

2.2 CONNECTING NETWORK

To configure the FL X1, it's necessary to connect the device to a PC, either directly or using an
Ethernet network, as described in the following paragraphs.
2.2.1

CONNECT TO PC DIRECTLY

Connect device and PC with a network cable through RJ 45 port (Ethernet port), as shown below:
The default IP address on device is 192.168.2.10. Therefore, set PC IP address in the same network
segment, for example, 192.168.2.1
Follow the steps below to set PC IP address at 192.168.2.1:

Right click on the network icon at right side of the Windows task bar

Select "Open Network and Internet settings " o "Open Network and Sharing Center"
(depending on the Windows version)

Click on Ethernet

Select [Properties] or [IP Settings]

Click on "Internet Protocol Version 4(TCP/IPv4)]" or "IP Settings"

Select [Use the following IP address]. Fill [IP address] and [Subnet mask], as shown below:
FL X1 User Manual 12