Advertisement
Figure 1. Strip Wire Insulation
IMPORTANT!
Not grounding this product, as described in the section,
"Warnings and Considerations," may result in an installation less immune
to damage caused by electrical disturbances, such as ESD or lightning,
and may void the warranty.
4
Identify and connect the keypad wires to the wallbox wires using the terminal
block as shown in Figure 2 below.
Figure 2. Keypad Wiring
TIP:
If you are using a Control4 push-on (screwless) faceplate in a multi-
gang installation, attach the black faceplate sub-plate to all of the devices
that will be installed into the wallbox prior to attaching the devices to the
wallbox. This will help ensure that all the devices are properly aligned and
on the same plane after installation.
5
Fit the wires back into the wallbox. Bend the wires in a zigzag pattern so that
they easily fold into the wallbox.
6
Align the keypad to the wallbox (the model # label should be at the bottom)
and fasten it with screws. Tighten the screws until the back side of the yoke
plate is even with the wall surface, but no further. Overtightening can warp
the configurable keypad and cause mechanical malfunction.
7
Install the Top Actuator Bar, Bottom Sensor Bar, and buttons as described in
the Keypad Button Installation Guide.
8
Install the Control4 Faceplate following the instructions in the Faceplate
Installation Guide or attach a standard Decora-style faceplate.
Copyright ©2013 Control4. . All rights reserved. Control4, the Control4 logo, the Control4 iQ logo and the Control4 certified logo are registered trademarks or trademarks of Control4 Corporation in
the United States and/or other countries. All other names and brands may be claimed as the property of their respective owners Pricing and specifications are subject to change without notice
9
Turn ON mains electrical power at the consumer unit.
Operation and Configuration
On initial power up, all status LEDs on the keypad will illuminate green indicating
that the device has power. Until the keypad has been configured into a Control4
system, it will not control any loads. To set up this keypad for use with a Control4
system, refer to the Composer Pro User Guide.
Button Tap Sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single (1) button should use the top-most button installed on the
keypad. Button tap sequences requiring two (2) buttons should use the top-most
and bottom-most buttons installed on the keypad.
Function
Identify
ZigBee Channel
Reboot
Factory Reset
Leave Mesh and Reset
Troubleshooting
If the LEDs do not light up indicating that the keypad is receiving power::
•
Ensure circuit breaker is not turned OFF or tripped.
•
Check for proper wiring (see Step 2 in "Installation Instructions").
•
For help on the installation or operation of this product, email or call the
Control4 Technical Support Center. Please provide your exact model number.
Contact support@control4.com or see the web site www.control4.com.
Care and Cleaning
•
Do NOT paint the keypad or its wall plate.
•
Do NOT use any chemical cleaners to clean the keypad.
•
Clean surface of the keypad with a soft damp cloth as needed.
Regulatory/Safety Information
To review Regulatory information for your particular Control4 products, see
the information located on the Control4 website at: http://www.control4.com/
regulatory/.
Patent Information
Applicable patents are available at http://www.control4.com/legal/patents.
Warranty
For complete warranty information, including details on consumer legal rights as
well as warranty exclusions, review the Warranty card or visit www.control4.com/
warranty.
About this Document
Part Number: 200-00352, Rev. C 8/7/2013 MS
Button Sequence
4
7
15
9-4-9
13-4-13
Advertisement
