ekwb EK-DBAY D5 Installation And Mounting Manual

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the
liquid seal is made using O-rings. The use of an algaecide and corrosion inhibitors is always recommended for any liquid cooling system.
STEP 1: GENERAL INFORMATION
POM Acetal reservoir body
Integrated anticyclone
Vibration Damper
With M3 threads
STEP 2: PREPARING THE PUMP
EK-DBAY D5 reservoir is only compatible with the Xylem/Laing D5 Vario or PWM pump. Before installation remove main pump motor/body from the stock or any
other third party pump top.
STEP 3: ASSEMBLING THE EK-DBAY D5 Reservoir
Take your Xylem/Laing D5 pump. Place it according to the picture. Do not forget to place the O-ring accordingly. Use enclosed Allen key to secure the pump with
eight (8) M4×16 DIN7380 screws.
Do not use excessive force when tightening the screws! Overtightening the screws will stripp the M4 threads rendering the product useless.
M4×16 DIN7380 screw
Installation and mounting manual for EK-DBAY D5 (incl. pump) reservoir
Sample picture of EK-DBAY D5 reservoir.
EK-D5 Vario Motor (12V DC Pump)
EK-D5 PWM Motor (12V DC Pump)
D5 Pump motor
D5 X-TOP RING
Motor)
Motor)
Gasket (OR 60x3)
www.ekwb.com
G 3/8 threaded fill port
Acrylic front plate
Pump suction port:
- small hole enables coolant to flood the
pump for easier system filling
- lower port disables sucking air from the
surface at higher flow.
MIN, MAX indicator
Placing the O-ring
Revision 1.1. Released on 4
for updates. Before
th
of June, 2014