ekwb EK-Classic DP Side PC-O11D G1 D-RGB + DDC 3.2 PWM User Manual

ekwb EK-Classic DP Side PC-O11D G1 D-RGB + DDC 3.2 PWM User Manual

Distribution plate

Advertisement

EK-Classic
DP Side PC-O11D G1 D-RGB + DDC 3.2 PWM
DISTRIBUTION PLATE
USER GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EK-Classic DP Side PC-O11D G1 D-RGB + DDC 3.2 PWM and is the answer not in the manual?

Questions and answers

Summary of Contents for ekwb EK-Classic DP Side PC-O11D G1 D-RGB + DDC 3.2 PWM

  • Page 1 EK-Classic DP Side PC-O11D G1 D-RGB + DDC 3.2 PWM DISTRIBUTION PLATE USER GUIDE...
  • Page 2 O-ring gaskets. The use of corrosion inhibiting coolants is always recommended for any liquid cooling system. EKWB recommends any of the EKCryofuel for worry-free usage. - 2 -...
  • Page 3: Table Of Contents

    TABLE OF CONTENT INSTALLING THE DISTRIBUTION PLATE ON THE PC RECOMMENDED DISTRIBUTION PLATE CONFIGURATIONS ATTACHING THE FITTINGS CONNECTING THE D-RGB LED STRIP CONNECTING THE PUMP TESTING THE LOOP SUPPORT AND SERVICE SOCIAL MEDIA - 3 -...
  • Page 4: Installing The Distribution Plate On The Pc

    INSTALLING THE DISTRIBUTION PLATE ON THE PC STEP 1 Remove both side panels from the PC case. STEP 1 STEP 2 Place the distribution plate in the right position inside the PC case and install it with twelve M4x8 screws from the backside. M4x8 DIN 7984 (12x)
  • Page 5: Recommended Distribution Plate Configurations

    RECOMMENDED DISTRIBUTION PLATE CONFIGURATIONS ATTACHING THE FITTINGS RADIATOR 1 In order to complete your loop, all of the ports should be used as INLET marked on the diagrams. RADIATOR 1 FILL All remaining and unused ports should be closed using the OUTLET supplied plugs and a 6mm Allen key.
  • Page 6 CONFIG 2 Configuration with two radiators RADIATOR 1 INLET RADIATOR 1 FILL OUTLET FILL CPU OUTLET CPU INLET OUTLET (one must be used) DRAIN GPU INLET (one must RADIATOR 2 be used) INLET RADIATOR 2 OUTLET CONFIG 2 - 6 -...
  • Page 7: Connecting The D-Rgb Led Strip

    CONNECTING THE D-RGB LED STRIP Plug the 3-pin connector of the distribution plate D-RGB LED light to the D-RGB HEADER on the motherboard. The LED will work if the pin layout on the header is as follows: +5V, Digital, Empty, Ground. Please ensure that the arrow indicated on the connector is plugged into the +5V line as indicated on your motherboard.
  • Page 8: Connecting The Pump

    CONNECTING THE PUMP STEP 1 The EK-DDC 3.2 PWM has two connectors: 1. 4-pin Molex: It must be connected directly to your PSU at all times as it is used to power the pump. 2. 4-pin PWM fan: It can be connected to your motherboard’s CPU_ Fan or designated water pump header.
  • Page 9: Support And Service

    SUPPORT AND SERVICE For assistance please contact: http://support.ekwb.com/ EKWB d.o.o. Pod lipami 18 1218 Komenda Slovenia - EU SOCIAL MEDIA EKWaterBlocks @EKWaterBlocks ekwaterblocks EKWBofficial ekwaterblocks...

Table of Contents