Troubleshooting - Vex Robotics VEXnet Joystick Setup

Setup
VEXnet Joystick Configuration

Troubleshooting

Slow blinking green ROBOT light on the Cortex
Issue:
Solution:
Slow blinking ROBOT green light on the VEXnet Joystick
Issue:
Solution:
LEDs starts blinking green. Release it, wait for another 5 seconds, and then turn
the VEXnet Joystick OFF and then back ON. If that fails, download the VEXnet
Joystick Firmware using ROBOTC.
Yellow or red ROBOT light on the Cortex
Issue:
Solution:
Yellow or red ROBOT light on the VEXnet Joystick, even though they are
Issue:
both green on the Cortex.
Solution:
© 2011 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems
Download the Cortex Master Firmware using ROBOTC.
Push and hold CONFIG button for about 5 seconds, until the status
Make sure you are using fully charged Robot battery.
Power cycle both the VEXnet Joystick and CORTEX.
in ROBOTC
(cont.)
VEX Cortex Configuration over USB
ROBOTC
• 12