Download Print this page

Advertisement

Quick Links

Wing Span:38.7in/980mm;
Wing Area:19sq.dm;
Length:34.6in/880mm;
CAUTION : this plane is not a toy and should be kept away
children under 16 years of age! Before use , please carefully read
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children's reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model's assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Flying Weight:520g;
Radio:4channels 3servos;
Outer Runner Brushless Motor.
P.1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Extra 330L and is the answer not in the manual?

Questions and answers

Summary of Contents for Turnigy Extra 330L

  • Page 1 Wing Span:38.7in/980mm; Flying Weight:520g; Wing Area:19sq.dm; Radio:4channels 3servos; Length:34.6in/880mm; Outer Runner Brushless Motor. CAUTION : this plane is not a toy and should be kept away children under 16 years of age! Before use , please carefully read this manual. ●First-time builders should seek advice from people having building experience in order to assemble the model correctly and to produce its performance to full extent .
  • Page 2: Aileron Servo

    AILERON SERVO Cut away covering film for the servo. Put the servo into the hole. Pull out the servo extension from main wing.
  • Page 3 Connect the aileron and the main wing by hinges. Be sure to apply instant type glue to both sides of each hinges. Bent the pushrod as shown. Link the servo arms and tri-horns with pushrod.
  • Page 4 Connect the main wings and the fuselage with joiner. Use two 4mm nylon bolts of each sides to ensure the wings fixed upto the fuselage. ELEVATOR & RUDDER SERVO Find and cut the hole for vertical fin. Find and cut the hole for stabilizer assembly and rudder servo .
  • Page 5 Insert and glue the vertical fin . Assemble the rudder servo. Insert and glue the stabilizer. Assemble the elevator servo. Apply instant type glue to both sides of each hinges of the rudder.
  • Page 6: Landing Gear

    Screw four TP screws to fix up the tail wheel on the tail of the fuselage. As shown in picture, This is finished for the tail wheel. LANDING GEAR Install the wheels to the landing gear.
  • Page 7 Find and cut the hole for landing gear assembly. Screw two TP screws to lock the landing gear to the fuselage. CANOPY Slide the rubber backed washers on the hatch mounting bolts and insert bolts through the hatch mounting holes and into the fuse blind nuts.Tighten snugly but do not over tighten and crush the hatch or the fuse...
  • Page 8 Movable canopy is convenient for you to install batteries and ESC ect. MOTOR Gather Motor,ESC,battery and spare parts as shown. Fixup the the motor before install to the model.
  • Page 9 Install the motor to motor mount by 4 screws. The finished picture as shown. Install the battery and the ESC as shown. Install the cowling with 4 TP screws.
  • Page 10 Adjustment Warning: Never jump this step before flight. P.10...
  • Page 11 CG POSITION & CONTROL THROWS P.11...
  • Page 12 FINISHED PHOTO P.12...
  • Page 13 P.13...
  • Page 14 P.14...
  • Page 15 P.15...
  • Page 16 P.16...