Advertisement
Quick Links
Wing Span: 62.2in/1580mm;
Wing area:41sq.dm;
Length:56.7in/1440mm;
Glow & electric RC model;
CAUTION:This plane is not a toy.
Before use,please carefully read this manual.
● First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
Performance to full extent.
● Assemble this kit only in places out of children's reach!
● Take enough safety percautions prior to operating this model.
You are responsible for this model's assembly and safe operation!
● Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Engine:2cycle 60,4cycle91;
Radio:4channels 5sevors;
Flying Weight:3000g;
1
Advertisement
Related Manuals for Turnigy Turbo Raven
Summary of Contents for Turnigy Turbo Raven
- Page 1 Wing Span: 62.2in/1580mm; Engine:2cycle 60,4cycle91; Wing area:41sq.dm; Radio:4channels 5sevors; Length:56.7in/1440mm; Flying Weight:3000g; Glow & electric RC model; CAUTION:This plane is not a toy. Before use,please carefully read this manual. ● First-time builders should seek advice from people having building experience in order to assemble the model correctly and to produce its Performance to full extent.
- Page 2 Cut away covering film for the servo on the botom of the main wing .. Connect the aileron and the main wing by hinges. Be sure to apply instant type glue to both sides of each hinges. Insert the servo and pull out the servo extention line from prepared holes .
- Page 3 Attach the main wing to the fuselage by bolt. Connect the main wings and the fuselage with joiner. Use two 5mm screws of each sides to ensure the wings fixed upto the fuselage. Find out the holes on each sides of the tail fuselage.
- Page 4 Glue the stablilizer to the fuselage. Connect the aileron and the stabilizer by hings, and glue them. Bent the piano wire as shown. Insert the tail wheel landing gear into the rudder.Then glue it.
- Page 5 Apply instant type glue to both sides of each hinges of the rudder. Screw four TP screws to fix up the tail wheel on the tail of the fuselage. Link the elevator servo to the elevator with pushrod. Repeat above steps for other side elevator assembly.
- Page 6 Loop the cable back through the brass swage tube as shown. Crimp the brass tube with a crimping tool or pliers. Rudder servo assmble on rudder view. Fixup the tri-horns on both sides of the rudder,then link the collet . Rudder servo assemble in fuselage view.
- Page 7 Screw the wheel to the landing gear. Be assured that the screw is fixed up. Install the wheel cover, and fix it up to landing gear with TP screw. Drill three holes on the landing gear as shown. Fixup the landing gear strut to fuselage with 3 bolts.
- Page 8 Install the throttle servo and the throttle rod as shown. FULE TANK INSTALLATION. Install the fuel tank into the fuselage, and fixup it with belt. Install the engine mount on both sides with four 3mm screws.
- Page 9 Use the ruler to measure the length from firewall to airscrew, which should be 118 MM. Fixup the canopy with TP screw on each side of the canopy. Install the cowling with four TP screws. Install the motor with the separate part provided.
Need help?
Do you have a question about the Turbo Raven and is the answer not in the manual?
Questions and answers