GE AF-650 GP Design And Installation Manual page 59

Application Setup Examples
CAUTION
Thermistors must use reinforced or double insulation to
meet PELV insulation requirements.
6 6
Table 6.10 Motor Thermistor
6-4
TM
AF-650 GP Design and Installation Guide
Parameters
Function Setting
F-10 Electronic [2]
Overload Thermistor
trip
F-12 Motor [1] Analog
Thermistor Input input 53
* = Default Value
Notes/comments:
If only a warning is desired,
F-10 Electronic Overload should
be set to [1] Thermistor warning.
Table 6.11 Mechanical Brake Control
Figure 6.4
In the upper right corner of the keypad, two numbers are
shown, e.g. 1(1). The number outside the parenthesis is the
active setup and the number inside the parenthesis is the
setup which will be edited. Default will always be 1(1).
Make sure you edit setup 1.
DET-767A
Parameters
Function Setting
E-24 Function [32] Mech.
Relay brake ctrl.
E-01 Terminal 18 [8] Start*
Digital Input
E-02 Terminal 19 [11] Start
Digital Input reversing
F-24 Holding 0.2
Time
F-25 Start [5] Advanced
Function Vector
Control/FLUX
Clockwise
F-29 Start Im,n
Current
B-20 Release Application
Brake Current dependent
B-21 Activate Half of
Brake Speed nominal slip
[RPM] of the motor
* = Default Value
Notes/comments: