PDU8000 Modular Precision PDC V2.0 User Manual Issue Date 2018-01-25 HUAWEI TECHNOLOGIES CO., LTD.
Notice The purchased products, services and features are stipulated by the contract made between Huawei and the customer. All or part of the products, services and features described in this document may not be within the purchase scope or the usage scope. Unless otherwise specified in the contract, all statements, information, and recommendations in this document are provided "AS IS"...
You are not allowed to modify configuration parameters without permission when using the modular precision PDC. If a modification is necessary, contact Huawei technical support. Huawei shall not be responsible for any loss caused by unauthorized configuration modification.
Only trained and qualified personnel are allowed to install, operate, and maintain the equipment. Only personnel certified or authorized by Huawei are allowed to replace or change the equipment or components (including software). Any fault or error that might cause safety problems must be reported immediately to a supervisor.
Step 1 Check whether the tiltwatch indicator on the carton has turned red. If yes, record the information and contact the equipment carrier and the local Huawei office immediately. Step 2 Visually inspect the equipment appearance to check whether the equipment is paint-peeling, misshapen, scratched, or soaked.
Altitude: < 2000 m (derated when the altitude exceeds 2000 m). For the derating details, contact Huawei technical support. Huawei will not be liable for any consequences caused if the installation environment does not meet the requirements. 5.2 Installation Preparations...
This table may not list some tools required at specific sites. Site installation personnel and technical support personnel should prepare tools based on site requirements. Prepare firestop putty for sealing cable holes after cable connection. Huawei does not provide the firestop putty. The customer needs to purchase it. 5.2.3 Checking Personnel Requirements Construction personnel must have basic knowledge of safe operation, be trained to master correct operation methods, and have the appropriate job qualifications.
8 Maintenance Guide 8.4 Parts Replacement This document describes only the replacement method for certain components. If a faulty component to be replaced is not covered in this document, contact Huawei technical support. 8.4.1 Replacing an SPD Module Prerequisites Do not replace an SPD module during a thunderstorm.