Agilent Technologies 100 Operator's Manual page 34

4 Operating the 100
The example on page 33 indicates the previously programmed test length for
Position 1 was 30 minutes.
2 In the display, the numeral 2 flashes, alternating with the previously
The above example indicates the previously programmed delay time for Position
2 was 5 minutes.
NOTE
3 In the display, the numeral 2 flashes again, this time alternating with the
The example on page 34 indicates the previously programmed test length for
Position 2 was 40 minutes.
34
• To accept the current test length, press ENTER.
• To change it, enter the new value in hhmmss format and press ENTER.
• To disable Position 1, enter 000000 for the test length and press ENTER.
programmed delay time for Position 2 in hhmmss format. The delay time is
the amount of time between the start of the program and the start of dipping
for Position 2. For example, you may see the following alternating displays:
POSITION 3
2
• To accept the current delay time, press ENTER.
• To change it, enter the new value in hhmmss and press ENTER.
• If no delay is desired, enter 000000 and press ENTER.
There is no delay time for Position 1.
previously programmed test length for Position 2. For example, you may see
the following alternating displays:
POSITION 3
2
• To accept the current test length, press ENTER.
• To change it, enter the new value in hhmmss and press ENTER.
POSITION 3
000500
POSITION 3
004000
100 Operator's Manual