Replacing The Paper Roll - Agilent Technologies 100 Operator's Manual

5 Troubleshooting and Maintenance
If you get ribbon ink on the printer's plastic cover, remove it immediately. Once
dried, it is difficult to remove.

Replacing the Paper Roll

1 Toggle the printer off line by pressing the printer toggle switch to the OnLine /
2 Grasp the paper roll cover firmly by the grooves on the side and the front edge.
3 Press the printer toggle switch to Paper feed to advance the paper
4 Using scissors, cut the paper feeding to the printer and remove the paper roll.
5 Pull the remaining paper through the printer mechanism. Pull the paper from
6 Unroll several inches of paper on the new roll.
7 If it is jagged, cut a straight edge on the paper roll to facilitate the entry of the
8 Slide the paper through the slot connecting the paper compartment and the
9 While holding the paper in place, press the printer toggle switch to the Paper
C A U T I O N
10 Release the printer toggle switch.
11 Turn the paper roll to take up any slack in the paper feeding to the printer.
12 Place the paper roll into the paper compartment.
46
Off Line position. When the printer is off line, the Ready LED does not
illuminate.
Pull outward to remove the cover.
approximately one inch beyond the paper cutter.
the front (paper cutter side). Pulling the paper out of the back of the printer will
damage the print mechanism.
paper into the printer.
printer compartment. You can slide it in approximately 1/4 inch before it
stops.
feed position and hold until approximately one inch of paper has emerged
from the top of the printer.
Ensure the roll of paper feeds squarely. If it does not, the paper
can jam and possibly damage the printer mechanism.
100 Operator's Manual