Table of Contents
Advertisement
8.2
Setting Up For A Run (Ready Mode)
KEY
1.
NEXT
2.
ENTER
3.
NEXT
4.
ENTER
5.
ENTER
6.
NEXT
7.
ENTER
8.
NEXT
DISPLAY
LOGGING DISABLED
LOG INTRVL 600s
TAG#:
4
ALARM: OFF
ALARM: INSTANT
3
LEVEL:1.50 mg/m
ALARM: STEL
3
LEVEL:0.50 mg/m
ANALOG OUTPUT:
DISABLED
ANALOG OUTPUT:
3
0 – 0.400 mg/m
CAL FACTOR: 1.00
DIS AVG TIME 10s
24
NOTES
This screen indicates the
logging status. To enable
the logging function, key
ENTER. Toggling of the
on/off logging status can
be done by keying ENTER.
This message indicates that
logging is enabled. Example is
for 10-min log period, selected
through the PC (see Section
9.0), and next free tag is #4.
This screen indicates the
alarm status. Keying ENTER
repeatedly toggles through
the 3 alarm modes:
This enables the alarm based
on the real-time concentration.
The level (e.g. 1.50 mg/m
must be set on the PC.
This enables the alarm based
on the 15-min STEL value.
The level (e.g. 0.50 mg/m
must be set on the PC.
This screen indicates the analog
signal output status. Keying
ENTER will enable the analog
output. Toggling the analog
output on/off can be done
by keying ENTER:
This enables the analog output.
The concentration range (e.g., 0
3
– 0.400 mg/m
) must be set on
the PC.
This screen displays the
calibration factor and the display
averaging time. Edit via PC
__
3
)
3
)
Advertisement
Table of Contents
