Download Print this page

Specifications; Power Supply - Makita MLT100N Instruction Manual

Hide thumbs


Table of Contents
ENGLISH (Original instructions)


Arbor hole
(Country specific)
Blade diameter
Max. cutting capacities
No load speed
Table size (L x W)
with sub tables (R) and (back)
Dimensions (L x W x H)
with sub tables (R) and (back)
Net weight
Safety class
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
Specifications may differ from country to country.
The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
The followings show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Do not place hand or fingers close to the
Make proper clearance between the saw
blade and riving knife.
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Intended use
The tool is intended for cutting in wood.
Straight cutting, bevel cutting, and miter cutting are
available with this tool. This tool is not designed for non-
through cutting.
bevel 0°
bevel 45°
835 mm x 1,305 mm (tables extended)
685 mm x 955 mm (tables stored)
726 mm x 984 mm x 473mm (tables stored)

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
The typical A-weighted noise level determined accord-
ing to EN62841-3-1:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
Wear ear protection.
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
30 mm / 25.4 mm
260 mm
93 mm
64 mm
4,300 min
34.8 - 35.1 kg
) : 89 dB(A)
) : 100 dB (A)


Table of Contents