Store And Recall Codes - Racal Instruments 2251A Operator's Manual

3.12

Store and Recall Codes

3.12.1 The 2251A permits the user to store and recall information about the setup and its
parameters.
Recall unit type
Recall master software issue
Recall GPIB software issue
Store/Recall Display resolution
(Defaults to 8)
Store/Recall trigger level A
(Defaults to 0V)
Store/Recall trigger level B
(Defaults to 0V)
Store/Recall math constant X
(Defaults to 0)
Store/Recall math constant Y
(Defaults to 1)
Store/Recall math constant Z
(Defaults to 1)
Store/Recall arming delay time
(Defaults to 200 Fs)
Store/Recall gate time
(Defaults to 100 ms)
Store/Recall memory (0 through 9)
Store/Recall special function
(Defaults to all SFs off)
NOTES: 1.
2.
3-16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 3.13 - Store and Recall Codes
Function
Recalled values do not cause the "Reading Ready" bit in the status
byte to be set nor the SRQ to be asserted, even if masked.
Storing a trigger level value is only allowed if Manual Trigger is
enabled (AMN, BMN). Attempting to store a trigger level when auto-
trigger (AAU, BAU is enabled will result in an error.
Code
RUT
RMS
RGS
SRS/RRS
SLA/RLA (See NOTE 1)
SLB/RLB (See NOTE 1)
SMX/RMX
SMY/RMY
SMZ/RMZ
SDT/RDT
SGT/RGT
SM/RM (See NOTE 2)
S/RSF