Advertisement
M
C
S
o
e z z o
o n v e r g e n t
y n e r g y
w n e r
f
10 – b
M
igure
olting the
ezzo
(See Figure 9).
Note: Do not tighten the nut at this time. Wait until the fine-tuning has been completed
for the entire system and the speaker has been leveled.
Note: Four small brass disks have been provided for use as spike pads. Place these under
the spikes to protect the finish of your floors.
3. Using provided 3/16 Allen wrench, remove the 4 setscrews from the bot-
tom of the Mezzo Convergent Synergy. Keep these as they are the setscrews
needed to assemble your spikes and may be required during final setup.
W i l s o n A u d i o S p e c i a l t i e s
46
'
M
S
a n u a l
a
b
nchor
olt
c
s
s
onVergent
YnergY to the
tand
s
4 . 5 — s
e C T i O n
e T u p
f
11 – l
s
s
igure
ocating the
et
4. Bolt the Mezzo Convergent Synergy to the stand using the four 3/8 – 16
threaded socket head cap screws and washer provided (see Figure 10).
Note: Do not overtighten the bolts; a snug fit is all that is required to secure the Mezzo
Convergent Synergy to the stand.
5. Turn to Section 4.7 for final assembly instructions.
The Hourglass Stand
1. Set the stand in the desired listening location.
Note: Please read Section 5 — Final Voicing before spiking the Mezzo.
2. At tach the spikes to the bot tom of the stand by screwing the spike and nut
combination until the nut is flush with the bot tom.
Mount the set screws into the bot tom of the Mezzo Convergent Synergy (Figure 11).
W i l s o n A u d i o S p e c i a l t i e s
# 2 M
C
s
e z z O
O n v e r g e n T
y n e r g y O n a
S
S
4
et
creW
placeS
a
k
e
S
llen
ey
nd oF
et
crews
s
T a n d
S
creW
47
Advertisement
