Advertisement
M
C
S
o
e z z o
o n v e r g e n t
y n e r g y
w n e r
(see Figure 8). The default rotation is set by using a combination of a spike, nut, and a
S
(
pacerS
uSe only iF
)
indicated in table
d
, S
,
iode
pike
n
and
ut
f
8 – i
M
c
igure
nstalling the
ezzo
onVergent
diode. If required, additional rotation can be achieved by using the provided 1/2" spacers
between the diode and the bot tom of the cabinet (see Figure 8). The amount of rotation
depends on your listening position.
Set the rotation as follows:
1. Remove the casters from the bot tom of the Mezzo Convergent Synergy. In-
sert the spike with nut in their place. Turn to Section 10, table 1, locate your
listening position on the table.
2. Assemble the front spikes with the listed diode/spacer combination in Table
1 (see also Figure 5).
3. Install the spikes as shown in Figure 9 above.
Note: the material used for the bottom of the Mezzo Convergent Synergy Wilson's pro-
W i l s o n A u d i o S p e c i a l t i e s
44
'
M
S
a n u a l
S
pike and
n
o
ut
nly
s
s
YnergY
pikes
s
4 . 5 — s
e C T i O n
e T u p
prietary high density composite X-material. While very hard, X-material is easily cross
threaded when installing the spikes. Be careful that the spike thread is engaging prop-
erly into the bottom.
t
S
hreaded
pikeS
f
9 – i
igure
nstalling the
•
4. Carefully lift the Mezzo Convergent Synergy into the desired location
and set it down.
Note: Four small brass disks have been provided for use as spike pads. Place these under
the spikes to protect the finish of your floors.
•
5. Turn to Section 4.7 for final assembly instructions.
Section 4.5—Setup #2 Mezzo Convergent Synergy on a Stand
1. Set the stand in the desired listening location.
2. Referring to Section 4.2, at tach the spikes to the bot tom of the stand by
screwing the spike and nut combination until the nut is flush with the bot tom
W i l s o n A u d i o S p e c i a l t i e s
# 2 M
C
s
e z z O
O n v e r g e n T
y n e r g y O n a
M
c
s
s
s
ezzo
onVergent
YnergY
tand
pikes
s
T a n d
45
Advertisement
