Table of Contents
Advertisement
Figure 31: Scope rail and rings (installation screw holes highlighted in blue).
Ring Use
Once the rings are installed around the OTA with the two scope rails attached, each segment has two
set screws located underneath each of the cutouts. These set screws ensure the fit around the tube is
snug, and should be adjusted as equally to ensure the tension between the two is even. Once these
have been adjusted so the telescope can no longer move, the telescope can be installed on the mount.
See the document "Paramount Taurus Scope Installation and Scope Rail Use" for the instructions to
installing the telescope in the Paramount Taurus.
P a g e
| 23
Advertisement
Table of Contents
Need help?
Do you have a question about the Paramount OTA Ring and is the answer not in the manual?
Questions and answers