Table of Contents
Advertisement
Figure 27: Versa-plate cable channel and instrument panel holes (bottom view).
Figure 28: Declination gear cable channel.
Ensure the cables run along the channel underneath the Versa-Plate, as well as in the cutout of the
Instrument Panel shown in Figure 29. Install the four 10-32x1/2 in. SHCSs and screw them in most of the
way. To prevent cables from becoming crushed or pinched, double check that all run through this
cutout before fully tightening any of these twelve screws.
Once cables are in the clear, tighten down the four Instrument Panel screws followed by the eight Versa-
Plate mounting screws.
P a g e
| 20
Advertisement
Table of Contents
Need help?
Do you have a question about the Paramount OTA Ring and is the answer not in the manual?
Questions and answers