KKT KOLBE Sinus Insel TC9 Installation Instruction page 6

ENGLISH
Position the hanging plate
Position the hanging plate on the ceiling and then mark
the position of the screw holes.
The hanging plate should be securely fixed to the ceiling.
Fix the angle bars
4
Fix the angle bars to the hanging plate, using the 8 x M5 screws.
Extend the angle bars to the required height and then fix them
in position using the 16×M5 screws.
IMPORTANT:
The angle bars must have an overlap of AT LEAST 100 mm.
2
3
Fix the hanging plate
For wooden ceiling:
11 × ST4 (30 mm) screws
For cement ceiling:
6 × expansion bolts
5
Connect the ducting hose
4
If your cooker hood is going to be used in extraction mode,
then you should connect the ducting hose to the ceiling
adaptor at this point. Fix the upper chimney section to the
hanging plate, using the 4 × self tapping screws.
1
11x
6x
5
4
6