Page 3
Tianjin APT Science and Technology Co., Ltd. High-contrast 3.2inch IPS colorful matrix screen. Ergonomic external button design, easy to operate. Speed display : AVG SPEED, MAX SPEED, SPEED(Real-time). Kilometer / Mile : Can be set according to customers’ habits.
Page 4
Tianjin APT Science and Technology Co., Ltd. 0~9). *If the display has been set password power on, you need to input the right password before start. 7.2 Assist level operating Short press UP/DOWN button can change the assist level. Top assist level is 9, 0 for neutral.
Page 5
Tianjin APT Science and Technology Co., Ltd. * This feature needs to be supported by controller. 7.7 Data cleanup Press and hold UP & DOWN buttons together for 1 second can reset several temporary data, temporary data include AVG Speed / MAX Speed / Trip / Time.
Page 6
Tianjin APT Science and Technology Co., Ltd. darkness, ׀׀׀׀׀is brightness Display Setting Basic Setting Display Setting Basic Setting System Metric System Metric Brightness Brightness | | | | | Auto off Auto off Digital Scenes Digital Scenes Battery Ind Voltage...
Page 7
Tianjin APT Science and Technology Co., Ltd. Power Km/h - - - Voltage Percentage 8.6 Clock : Clock setting, press MENU button get into the clock setting menu, press UP/DOWN button to set Year/Month/Day/Hour/Min/Sec. Display Setting Display Setting Display Setting...
Page 8
Tianjin APT Science and Technology Co., Ltd. 24V/36V/48V/UBE,UBE means user define value. 8.9 Start password : Press MENU button get into the password setting menu. If you had set Start input ON, you must input right password before power on, password is accorded to your setting.
Page 9
Tianjin APT Science and Technology Co., Ltd. default password is ‘1919’. Speed limit Current limit Poles in motor Start after poles Clockwise Start Key antijam Assist levels Start mode Throttle Level Throttle 6km 8.11 Speed limit : Press UP/DOWN will change speed limit, range 10km/h~45km/h.
Page 10
Tianjin APT Science and Technology Co., Ltd. 8.14 Start after poles : How many poles (speed sensor) need to be detected by controller before starting motor. Default value is 3. 8.15 Clockwise start : This parameter represent speed sensor turn direction, default value is Y (forward).
Page 11
Tianjin APT Science and Technology Co., Ltd. 8.18 Start mode : Pow/ECO/STD represent Power/ECO/Standard, STD (default). Power mode means use maximum current when speed up, ECO mode means use minimum current. *This function is optional, may not supported by each mode.
Page 12
Tianjin APT Science and Technology Co., Ltd. 8.22 Information : Show information of the E-bike. 8.23 Product info : Get into this item can show hardware version software version… 8.24 Battery info : Get into this item can show all information of battery, including Voltage, Capacity, Cycle times, Health, Temperature of battery, Remaining Capacity, Full Charge Capacity.
Page 13
Tianjin APT Science and Technology Co., Ltd. Power Power Km/h Km/h - - - - - - 10. Assembly instructions Please pay attention to the screw’s torque value, damaged caused by excessive torque is not within the scope of the warranty.
Page 14
Tianjin APT Science and Technology Co., Ltd. 25.4mm and 22.2mm (marked with L or R) , transfer ring must be assembled with the special directions, pay attention to the green arrow below. 22.2 L Clamp L 11. Connector descriptions 1、 Red wire : Anode(24v/36v/48V) 2、...