•
• access the terminal block M1
• remove the jumper from the ends of contacts 1-2
•
When the external sensor is connected to the boiler, the
according to the set
pressing
as indicated in the chart in annex
E for selecting the most appropriate one (00 to 90).
KEY TO CHART -
To use this function, install the programmable relay electronic board supplied as an accessory.
KEY TO ELECTRICAL CONNECTIONS (see diagram in annex
Z
Zone (1..n)
EV
Zone electrovalve
R
Relay
Room thermostat
ambient thermostats can be used to control the other zones.
• Connect the zone 1 valve/pump to terminals 1 - 3 of the relay board terminal block inside the boiler control box.
• Connect the Ambient Thermostat contact of the other zones to terminals 1-2 of terminal block M1 (CONNECTING THE
AMBIENT THERMOSTAT section).
Check that parameter P04=02. Set parameter P10 (SETTING PARAMETERS section).
4-5)
Outside temp
at the end of this manual).
33
7651561.02 (1-03/16)