Table of Contents
Advertisement
Available languages
Available languages
• Press
•
•
the factory setting.
•
NG and does not recognise the type of gas used, press
seconds to exit the function and then change parameter P02=01 as described in the "PARAMETER SETTINGS" section of the
boiler instructions manual.
If the venting or gas recognition function is interrupted by a power blackout, start the function again when power is restored
by pressing
and
gas recognition function is interrupted due to a fault (e.g.: E133 no gas) press
6 seconds) to restart the function again. If the gas recognition function is interrupted due to overheating, restart the function by
pressing
and
and holding them down for at least 6 seconds.
The combustion of this appliance has been factory controlled, calibrated and set for operation with NATURAL GAS.
During the Gas Type Control Function, the combustion ratio will increase for a short period of time while the gas type is being
established.
seconds.
To enable the system gas extraction function press buttons
cycle. To manually exit this function, press the above buttons together for 6 seconds once again.
12.3 CHIMNEY SWEEPER
This function enables the boiler to generate
• Press buttons
and
• Press
• To exit press both buttons together for at least 6 seconds, as described in point one.
Press
7651561.02 (1-03/16)
NG
LPG, press
and
LPG. Press
together and holding them down for at least 6 seconds. If the display shows fault E118 (low pressure
303
On
000
and
to reset and then press
together for 6 seconds. When the function is active, On
312.
34
%
and
for at least 2
On
000
312
(for at least
Advertisement
Chapters
Table of Contents
