Xylem Rule LoPro LP900D Instruction Manual page 3

Precautions before work
Observe these safety precautions before you work with the product or are in connection with the product:
• Provide a suitable barrier around the work area, for example, a guard rail
• Make sure that all safety guards are in place and secure
• Make sure that you have a clear path of retreat
• Make sure that the product cannot roll or fall over and injure people or damage property
• Make sure that the lifting equipment is in good condition
• Use a lifting harness, a safety line and a breathing device as required
• Allow all system and pump components to cool before you handle them
• Make sure that the product has been thoroughly cleaned
• Disconnect and lock out power before you service the pump
• Check the explosion risk before you weld or use electric hand tools
Wash the skin and eyes
Follow these procedures for chemicals or hazardous fluids that have come into contact with your eyes or skin:
Condition
Chemicals or
hazardous fluids
in eyes
Chemicals or
hazardous fluids
on skin
WARNING: Radiation Hazard. Do NOT send the product to Xylem if it has been exposed to any nuclear radiation.
Electrical installation
For electrical installation recycling requirements, consult your local electric utility
Recycling guidelines
Always follow local laws and regulations regarding recycling
DANGER: This product is not intended for damage control or to deal with flooding resulting from hull damage.
This product is intended to be used in Bilge Pumping Systems for small craft with a hull length up to 24 meters,
as described within the introduction and scope of ISO 15083. Bilge Pumping Systems, as specified in ISO 15083,
are limited to normal amounts of water in an intact boat due to spray, rain, seepage, spillage, and occasional small
amounts of water shipped from boat movements in heavy weather. Use of product in any other way could result in
flooding, catastrophic damage to craft, serious personal injury, or death.
WARNING: This pump is designed for use with fresh water and salt water ONLY. Use with any other hazardous,
caustic, or corrosive material could result in damage to the pump and the surrounding environment, possible exposure
to hazardous substances and injury.
WARNING: Check the function of all bilge pumps at regular intervals. Clear pump inlets from debris. If
seacocks are fitted in the fore and aft peak bulkheads, they shall be kept closed and shall only be opened to let
water drain into the main bilges.
Action
1. Hold your eyelids apart forcibly with your fingers
2. Rinse the eyes with eyewash or running water for al least 15 minutes
3. Seek medical attention
1. Remove contaminated clothing
2. Wash the skin with soap and water for at least 1 minute
3. Seek medical attention, if necessary
STO P
STOP
C