Aalborg DPM Series Operating Manual page 50

Th h e e f f o o l l l l o o w w i i n n g s s e e t t t t i i n n g g s s a a r r e a a v v a a i i l l a a b b l l e f f o o r O O L L E E D D D D i i s s p p l l a a y y : :
a a ) ) D D i i s s p p l l a a y M M o o d d e e
This option determines whether the display screens are in static (manual
control) or dynamic (automatic sequencing) mode. Two selections are
available: Static or Dynamic. The default entry is Static (manual control).
b b ) ) S S c c r r e e e e n n C C y y c c l l e Ti i m m e
This menu selection defines the time interval in seconds for each PI screen
to be displayed in the dynamic mode (automatic sequencing). Screen Cycle
Time can be set to any value between 1 and 3600 seconds (numerical
entry).
c) PI Screen Configuration
Using Screen Configuration settings, the user can enable (unmask) or
disable (mask) up to 6 different process variable combinations (see
Figure 27). The screen is Enabled if the checkbox on the same line as the
corresponding screen is selected: [*]. If the screen is disabled, it will be
skipped. By default, the instrument is shipped from the factory with all PI
screens enabled, as indicated in Figure 27.
As explained, in the example shown above, all PI screens are enabled. Each PI
screen is assigned to a correspondingbitinthePIScreenRegister.Inorderto
changePIScreenConfiguration, the user should select the desired screen using
the joystick UP and DN buttons and thenpress theRIGHTbutton. Theasteriskwill
appear or disappearontheright sideof thecorrespondingscreen line. The
asterisk signifiesthat the screenisenabled. Inorderto disable the screen, the
corresponding asterisk must be removed. To accept and save new PI Screen
Configuration settings in the device's nonvolatile memory, press the joystick ENT
button.
d) OLED Operational Brightness (Numerical entry)
Using OLED Operational Brightness settings, the user can adjust the desired level
of OLED brightness during normal operation (when the screensaver is not active).
The OLED brightness has 256 differentlevels.
PI Screen Config:
Screen #1 [*]
Sc c r r e e e e n # # 2 2 [ [ * * ]
Sc c r r e e e e n # # 3 3 [ [ * * ]
Sc c r r e e e e n # # 4 4 [ [ * * ]
Sc c r r e e e e n # # 5 5 [ [ * * ]
Sc c r r e e e e n # # 6 6 [ [ * * ]
Figure 27: PI Screen Configuration
48