Aalborg DPM Series Operating Manual page 20

6. . 3 3 M e e t t e e r P P r r o o c c e e s s s I I n n f f o o r r m M
Based on meter configuration, different parameters may be displayed in the
Process Information (PI) screen by moving the control joystick (see Figure
7) Up or Down (DN). Process Information screens can be configured to be
static or dynamic (see Section 6.4.13.2 "Display and Process Information
(PI) Screens"). Using PI Screen Mask settings, the user can enable
(unmask) or disable (mask) up to 6 different process information
combinations.
In the Static Mode, moving the joystick Up pages through the PI screens in
the forward direction, while moving the joystick DN pages through the PI
screens in the reverse direction. When the last PI screen is reached, the
firmware "wraps around" and scrolls to the initial PI screen once again.
In the Dynamic Display Mode, the firmware initiates automatic screen
sequencing with user-adjusted screen Cycle Time (see Section 6.4.13.2
"Display and Process Information (PI) Screens"). When the last PI screen is
reached, the firmware "wraps around" and scrolls to the initial PI screen
once again.
m a a t t i i o o n ( ( P P I I ) ) s s c c r r ee e n n s
UP
LEFT
DOWN
FIGURE 7: JOYSTICK
18
Press here for
Enter command
RIGHT