Know Your Snow Thrower - White Outdoor SB 45 Operator's Manual

SECTION 3: KNOW YOUR SNOW THROWER
Read this owner's manual and safety rules and labels before operating your snow thrower. Compare the
illustrations in Figure 9 with your equipment to familiarize yourself with the location of various controls and
adjustments. Save this manual for future reference.
WARNING: The operation of any snow thrower can result in foreign objects being thrown into the
operator's eyes and causing severe eye damage. Always wear safety glasses while operating the
snow thrower, or while performing any adjustments or repairs on it.
Discharge Chute
IMPORTANT: This unit is shipped without gasoline or
oil. See separate engine operator's manual for proper
fuel and engine oil recommendations.
Auger Control Handle
Located on the upper handle, the auger control handle
is used to engage and disengage the augers. The
snow thrower is designed to be propelled by the
rotation of the augers. Pull the control handle back
against the upper handle to engage the augers;
release to disengage.
Chute Crank
Located on right side of dash panel, the chute crank
determines the direction that snow will be discharged.
Turn clockwise to discharge snow to the left; turn
counterclockwise to discharge to the right.
Discharge Chute
The angle of the discharge chute controls the distance
that the snow is thrown. Tilt the discharge chute up for
greater distance; tilt down for less distance. Loosen
the hand knob on the side of the discharge chute to
adjust. Tilt the chute to the desired position, and
tighten the knob.
Auger Control
Handle
Chute Crank
Shave
Plate
Auger
* Only on electric start models
Upper Handle
Spark
Primer
Plug Button
Cover
Choke Lever
Off
On
Figure 9
Choke Lever
Place choke lever in "ON" position to start a cold
engine.
Primer Button
Used to inject fuel directly into the carburetor to insure
fast starts in cold weather.Follow engine manual to
prime engine.
Ignition Key
Used to start engine. Put key in "ON" position to start.
Starter Handle
Used to manually start the engine.
Spark Plug Cover
Spark plug located under the cover.
Electric Starter
(If equipped)
This is used to start engine with a 120V power source.
Plug for Electric Start
The electric starter requires use of a two prong
outdoor extension cord and a 120V power source.
7
Ignition
Key
Electric
Starter*
Starter
Plug for
Handle
Electric
Cord*
(If equipped)