Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operator's Manual
Operator's Manual
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning:
This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered,
brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or
state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California
the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws
apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the
service department, P.O. Box 361131 Cleveland, Ohio 44136-9722.
WHITE OUTDOOR PRODUCTS COMPANY P.O. BOX 361131 CLEVELAND, OHIO 44136-9722
PRINTED IN U.S.A.
Model
SB 45
FORM NO. 770-10012C.fm
(5/2001)
Advertisement
Table of Contents
Related Manuals for White Outdoor SB 45
Summary of Contents for White Outdoor SB 45
- Page 1 A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-9722. WHITE OUTDOOR PRODUCTS COMPANY P.O. BOX 361131 CLEVELAND, OHIO 44136-9722 PRINTED IN U.S.A.
-
Page 2: Table Of Contents
Before you start assembling your new equipment, please locate the model plate on the equipment and copy the information from it in the space provided below. The information on the model plate is very important if you need help from your White Outdoor dealer. •... -
Page 3: Important Safe Operation Practices
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol—heed its warning. -
Page 4: Maintenance And Storage
White Outdoor dealer or telephone 1-800-949-4483 • Restrict the use of this power machine to persons who for the name of the nearest White Outdoor dealer. read, understand and follow the warnings and instructions in this manual and on the machine. -
Page 5: Assembling Your Snow Thrower
SECTION 2: ASSEMBLING YOUR SNOW THROWER Contents of Carton Before beginning installation, remove all parts from the carton and compare them to Figure 1. Carton contents are listed below with part numbers in parentheses. Upper Handle • Two Ignition Keys (725-0201 & 725-1341B) •... -
Page 6: Know Your Snow Thrower
• Rotate the chute directional control to align the hole Carriage Bolt Flat in the coupler with the hole in the chute directional Washer control, and insert the cotter pin through both holes. Lower Chute Lip Bend the ends of cotter pin in opposite directions to secure it in place. -
Page 7: Operating Your Snow Thrower
Spark Plug Cover This unit runs on a mixture of gasoline IMPORTANT: and oil. Do NOT operate the snow thrower without first Remove the spark plug cover to access the engine’s reading the Tecumseh Engines operator’s manual for spark plug located beneath it. instructions regarding proper fuel and engine oil. -
Page 8: Making Adjustments
Operating the Snow Thrower • Engage the auger by squeezing the control handle against the upper handle. See Figure 6. • Loosen the wing knob found on the left side of the • Lift up slightly on the handle to allow the rubber discharge chute and pivot the upper chute upward paddles on the auger to contact the pavement and or downward to the desired pitch. -
Page 9: Maintaining Your Snow Thrower
• If the extension spring is already found in the middle position on the idler bracket, move it from the middle position to the high position. Hex Screws • Reattach the belt cover with the five hex screws removed earlier. Shave Plate •... -
Page 10: Replacing The Drive Belt
Lubrication • Carefully slip the drive belt off the auger pulley, freeing it from the snow thrower. See Figure 10. • Lubricate pivot points on the control handle and the • Install the replacement drive belt by following the extension spring at the end of the control cable preceding steps in reverse order. -
Page 11: Off-Season Storage
Check for possible damage. Tighten all bolts and nuts. Repair as needed. If the problem persists, take unit to an authorized White Outdoor dealer. Unit fails to self-propel 1. Drive cable out of adjustment Adjust the control cable as instructed on page 8 of this manual. -
Page 12: Model Sb 45 Parts List
SECTION 9: MODEL SB 45 PARTS LIST... - Page 13 Model SB 45 REF. PART DESCRIPTION 710-0276 Splined Carriage Screw, 5/16-18 x 1.0 710-3015 Hex Cap Screw, 1/4-20 x.75 712-3068 Hex Lock Nut, 5/16-18 731-0851A Chute Flange Keeper 731-0915B Lower Chute, 5.0 731-0921 Upper Chute, 5.0 736-0159 Washer, .349 x .879 x .063...
- Page 14 Model SB 45...
- Page 15 Model SB 45 REF. PART REF. PART DESCRIPTION DESCRIPTION 684-0054A Dash Assembly 684-0114A Auger Housing Assembly (Includes Plastic Cup for Mitten Grip) 710-0167 Screw, 1/4-20 x .50 710-3013 Hex Cap Screw, 1/4-20 x .50 710-0191 Cap Screw, 3/8-24 x 1.25 710-3025 Hex Cap Screw, 5/16-24 x .625...
-
Page 16: Cleveland, Ohio
Products Co. with respect to new merchandise pur- d. White Outdoor Co. does not extend any warranty for chased and used in the United States, its possessions and products sold or exported outside of the United States territories.
Need help?
Do you have a question about the SB 45 and is the answer not in the manual?
Questions and answers