Assembling Your Snow Thrower - White Outdoor SB 45 Operator's Manual

SECTION 2: ASSEMBLING YOUR SNOW THROWER
Unpacking from carton
• Cut along corners of the carton and lay it down flat.
See Figure 1. Remove packing material.
• Remove any loose parts included with unit (i.e.,
operator's manual, etc.).
• Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
Remove loose parts
Figure 1
Hardware pack
(Figure 2)
1. Ignition Keys (2)
NOTE: One key is in the switch on the snow thrower.
2. Eyebolt
3. Saddle Washer 5/16" I.D.
4. Hex Nuts 5/16-18 Thread (2)
5. Cotter Pin
Ignition
Key
Eye Bolt
Figure 2
Items required for assembly
1. Pair of pliers (not necessary, but helpful)
2. Two cycle engine oil
3. Fresh gasoine
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
Raising upper handle
• Loosen the hand knob on each side of the handle.
Remove packing material, if any.
Roll unit out
Hex Nut
Saddle
Washer
Cotter
Pin
• Raise the upper handle in the direction shown in
Figure 3 till it clicks into the operating position.
Make sure not to pinch or crimp the cable.
• Tighten the hand knobs.
Attaching control cable
The control cable may already be attached to the
control handle. If not attached, complete the following
steps to attach it to the snow thrower housing.
Bottom
Hole In
Control
Handle
Control
Housing
• Route the control cable over the lower handle.
Insert the end of the cable into the hole in the
control housing as shown in Figure 4. Push the
plastic fitting until it locks into the control housing.
• Lift the control handle up, and hook the "Z" end of
the control cable into the bottom hole in the
control handle, from the outside to the inside. If
necessary, pull up on the end of the cable with a
pair of pliers to obtain slack in order to hook it into
5
Raise
handle
to here
Hand Knob
Figure 3
"Z" End
of Cable
Plastic
Fitting
Figure 4