Advertisement
Check Weighing
Before using this reference guide, enable and configure Check Weighing by following the steps listed in Chapter 7.1.3
of the Instruction Manual. To enter the Check Weighing mode press the "Function" key, and select the function by
pressing the "T" key while "Check" is displayed.
Upon entering the check weighing function, the UNDER limit is displayed. If an under limit has already been set
1.
and no change is necessary, press "T" (YES) to accept and continue. If you wish to change the setting, press the
"0 (NO)" key. To set a new weight limit use the table below.
AGC Series: Quick Reference Guide
1
Advertisement
Table of Contents
Related Manuals for Torbal AGC Series
Summary of Contents for Torbal AGC Series
- Page 1 AGC Series: Quick Reference Guide Check Weighing Before using this reference guide, enable and configure Check Weighing by following the steps listed in Chapter 7.1.3 of the Instruction Manual. To enter the Check Weighing mode press the “Function” key, and select the function by pressing the “T”...
- Page 2 AGC Series: Quick Reference Guide If an over limit has already been set and no change is necessary, press “T” (YES) to accept and continue. If you wish to change the setting, press the “0 (NO)” key. To set a new weight limit use the table shown in step1.
Need help?
Do you have a question about the AGC Series and is the answer not in the manual?
Questions and answers