Change Set Temperature; Invert Display - Balboa TP200 PANEL User Manual

5
CHANGE THE
SET TEMPERATURE
Change the Set Temperature
When using a panel with WARM and COOL
temperature buttons, pressing either WARM or
COOL will cause the Set Temperature to flash.
Pressing a temperature button again will adjust
the Set Temperature in the direction indicated
on the button. When the LCD stops flashing, the
spa will heat to the new Set Temperature when
required.
If the panel has a single temperature button,
pressing TEMP will cause the Set Temperature
to flash. Pressing TEMP again will cause the
Set Temperature to change in one direction (e.g.
UP). After allowing the display to stop flashing,
pressing the TEMP button will cause the Set
Temperature to flash and the next press will
change the Set Temperature in the opposite
direction (e.g. DOWN).
Temperatures are displayed in either Fahrenheit
or Celsius. This setting is hard-coded into the
control system.
Press-and-Hold
If a Temperature button is pressed and held
when the Set Temperature is flashing, the Set
Temperature will continue to change until the
button is released. If only one Temperature
button is available and the limit of the
Temperature Range is reached when the
button is being held, the progression will
reverse direction.
Balboa Water Group | Your Single Source Solution
SEQUENCE
Main Screen
Press the TEMP button. The Set
Temperature will appear and flash.
While the Set Temperature is flashing,
press TEMP repeatedly to change the
Set Temperature from 102 to 104. Your
setting will be saved automatically.
The Main Screen will appear • • •
momentarily after you stop pressing
TEMP. Or, press LIGHT to have the
Main Screen appear immediately.
SEQUENCE KEY
( View page 2 for full description )
Flashing characters
Progressive message
Press TEMP button for "action"
Press LIGHT button to "select"
Pause / back to Main Screen / setting not saved
Pause / back to Main Screen / setting saved

INVERT DISPLAY

Follow this sequence to invert the display.
This display is inverted (A), and this display is
not inverted (B).
A
B
6
SEQUENCE
Main Screen
Press the TEMP button. The Set
Temperature will appear and flash.
While the Set Temperature is
flashing, press LIGHT until
FLIP appears.
Press TEMP to flip the display.
°°°
Press LIGHT to save your setting.
The Main Screen will
appear automatically.
If you do not press LIGHT, your setting
will not be saved, and the Main Screen
will appear momentarily.
Follow the same sequence to restore
the default display orientation (B).
TP200 USER GUIDE 42375 Rev A1