Page 1
TP200 PANEL User Guide Simplified Menu Your Single Source Solution 42375 Rev A1...
Page 2
THANK YOU TP200T PANEL Single Temperature Button for using Balboa Water Group spa controls. TP200W PANEL Dual Temperature Buttons BP CONTROL SYSTEM All BP series systems that support Please visit us at Simplfied Menus www.BalboaWaterGroup.com...
Set Temperature and pause a few moments, the Main Screen will appear automatically, and your setting will be saved. The same applies to other features that will be discussed later. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Temperature. Two, you can navigate menus by pressing the LIGHT button. If you do not press any buttons for a few moments, the Main Screen will appear automatically. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
If only one Temperature button is available and the limit of the Temperature Range is reached when the button is being held, the progression will reverse direction. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Press TEMP button for “action” Press LIGHT button to “select” Pause / back to Main Screen / setting not saved Pause / back to Main Screen / setting saved Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
3°F (1.5°C) above the set temperature (most likely to happen in very hot climates). MODE 2: The circulation pump will stay on continuously, regardless of the water temperature. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42369 Rev A1...
If you press the JETS button while in Rest Mode, the spa will switch to Ready-In-Rest Mode (RRST) for one hour. The Main Screen will alternate between displaying the water temperature and RRST. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
PANEL MESSAGES This chapter contains helpful information to help keep your spa running smoothly. All panel messages are listed and explained. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Trapped air can restrict proper water flow. Remove trapped air by priming this pump. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42369 Rev A1...
* This message can be reset from the panel with any button press. * This message can be reset from the panel with any button press. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
The temperature sensor balance is poor. The temperature sensors may be out of sync. * This message can be reset from the panel with any button press. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Configuration Error – Spa will not Start Up. Contact your dealer or service organization. * This message can be reset from the panel with any button press. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Pumps are manufacturer. appropriate chemicals. shut down until this problem clears. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Page 16
Wood skirting and furniture should be cleaned Filters should be replaced occasionally to and conditioned per the manufacturers maintain proper spa function and instructions for maximum life. sanitary conditions. Balboa Water Group | Your Single Source Solution TP200 USER GUIDE 42375 Rev A1...
Page 17
Balboa Water Group or its respective • Disconnect the electrical power before servicing. Warning: To avoid injury, exercise care when entering suppliers relating to the Balboa Water Group BP Spa Control Systems, Attention: or exiting the spa or hot tub.
Page 18
TP200 PANEL Email Phone Corporate Office info@balboawater.com P : + 714.384.0384 Balboa Water Group Customer Service is available: 3030 Airway Avenue M - F 7:00AM to 6:00PM PT Costa Mesa, CA 92626 MEXICO OPERATIONS EUROPEAN OPERATIONS Balboa Water Group Balboa Water Group...
Need help?
Do you have a question about the TP200 PANEL and is the answer not in the manual?
Questions and answers