Table of Contents
Advertisement
Anti-vandal Deep Bases
Wall & Ceiling Mounting
The anti-vandal deep bases
offer extra room for easy
termination and to disguise
cabling and connections
for a neat finish.
They are designed for use
with the IP-CAM530/353
anti-vandal domes so they
fit perfectly.
Code:
Code:
Before you start
remove the upper
housing as shown in
"Mounting" step 1.
1
x4
x4
Screw
through
the four holes in
the bottom of the
base and into the
mounting surface
using the screws
and wall plugs
provided.
2
x4
Screw through the
camera's base and
into the deep base
using the short flat
screws provided.
3
x3
Tighten the three
Torx screws in the
upper
housing
(Torx key supplied).
Get more from your Zip NVR with our Free CCTV tips at
IP-BASE002B
(Black)
IP-BASE002W
(White)
Pole & Wall Bracket Mounting
A practical way to get the
ideal viewing angle. As well
as a wall bracket there are
200mm, 300mm and 500mm
ceiling brackets available.
Code:
IP-BRKT005B
(Wall)
Code:
IP-BRKT005W
(Wall)
Code:
IP-BRKT250B
(200mm)
Code:
IP-BRKT250W
(200mm)
Code:
IP-BRKT350B
(300mm)
Code:
IP-BRKT350W
(300mm)
Code:
IP-BRKT550B
(500mm)
Code:
IP-BRKT550W
(500mm)
First you'll need to fix the camera to the base as
shown in "Wall & Ceiling Mounting" steps 2 and 3.
1
Mark the fixing holes on
the mounting surface.
Drill and insert the four
anchor bolts provided.
With the bracket over
the anchor bolts, place
a washers, split ring
and then screw a nut
on to each exposed
thread to secure.
2
Screw the deep base
on to the end of the
ceiling/wall bracket.
Lock the base in-place
using the small slotted
grubs screws supplied.
When ceiling mounting
the mounting plates
is attached to the
opposite end of the
pole in the same way.
ZipNVR.com
5
Advertisement
Table of Contents
