Rola LRSA2 Pack Contents & Fitting Instructions

LOW MOUNT SOLID RAIL
PACK CONTENTS & FITTING INSTRUCTIONS
M8 FLAT WASHER M8 SPRING WASHER
(22-0195) (22-0162)
x12 x12
LOW MOUNT WITH END CAPS
x4 (25-0310 - 2 pack)
Each Low Mount contains
two end caps
1
Read instructions thoroughly before commencing
installation.
Refer to Titan Tray instructions for tray assembly.
Skip to Step 5 on the following page if you have
already inserted the interconnecting blocks.
3
For TFT1212, TFT1512 & TFT1812:
Insert the three interconnecting blocks between the four centre
planks.
Position interconnecting blocks in the centre of the tray.
For TFT2014:
Insert the four interconnecting blocks between the five centre
planks.
Position interconnecting blocks in the centre of the tray.
M8 HEX NUT
(22-0139)
x12
RAIL STRAP INTERCONNECTING BLOCK
x4 (25-0312)
x3 for TFT1212, TFT1512 & TFT1812
x4 for TFT 2014
NOTE: Fasteners supplied with Titan Tray are required for this fitment.
M8 T BOLT M5 x 10 BOLT
(22-0961) (92187)
x8 x8
UNDER-COVER STRIP
(32-0050)
x2
2
Place tray upside down. Remove fasteners on one side and
remove the end plank.
4
Re-install the end plank and fasteners.
Tighten fasteners securely.
LRSA2-FI
Revision 2, March 2020
ANCHOR NUT ALLEN KEY
(22-0959) (22-0055)
x8 x1
RUBBER PAD
(30-0030)
x4
M8 DROP-&-TURN
BOLT (22-0924)
x4