Winding The Bobbin Thread, Adjusting The Thread Tension - Pfaff 571 Instruction Manual

9

Winding the bobbin thread, adjusting the thread tension

.02
5
3
9
8
Fig. 9 - -03
● Fit the empty bobbin 1 onto the bobbin winder spindle 2 with the rest thread chamber on
the outside.
● Thread in the thread as shown in Fig. 9 - 03 and wind it round the bobbin 1 a few times in
an anti-clockwise direction.
● Switch on the bobbin winder by pressing the bobbin winder spindle 2 and the lever 3
simultaneously.
● The tension of the thread on the bobbin 1 can be adjusted with the knurled screw 4.
● The bobbin winder stops automatically when the bobbin 1 is sufficiently full.
● Remove the filled bobbin 1 and cut the thread with the knife 5.
● The fill amount of the bobbin 1 can be adjusted with the pin 8 (loosen the screw 9 and
tighten it again)
If the thread is wound unevenly:
● Loosen the nut 6.
● Turn the thread guide 7 accordingly.
● Tighten the nut 6
4
1
2
The bobbin fills up during sewing.
If the machine is only run for bobbin winding (without sewing), a bobbin case
must be fitted in the hook.
Otherwise a jammed thread may damage the hook!
Set-up
7
6
33