Table of Contents
Advertisement
Appendix
Possible Exceptions
Exception
AC power off
AC power on
Audit table lost
Coin drop 1 pulse too
short
Coin drop1 pulse too
long
Coin drop2 pulse too
long
Coin drop2 pulse too
short
Drain time too long
Factory reset
Fill time too long
Fill time too short
Free vend given
during service
routine
Internal backup table
bad
Internal main table
bad
Internal table lost
Invalid owner ID
Manual back in
service
Manual out of service
Reserved internal
exception
Service table lost
Setup table lost
Time: Fall back
Time: Spring
Forward
Washer lid did not
open
Cause
Unplugged or AC failed
Plugged in or AC turned on
N/A
Bad coin, fishing of drop, or incorrect coin acceptor set up.
Bad coin, fishing of drop or incorrect coin acceptor set up.
Bad coin, fishing of drop or incorrect coin acceptor set up.
Bad coin, fishing of drop or incorrect coin acceptor set up.
Drain time is greater than 15 minutes. This is only logged,
no action is taken.
N/A
Fill time is greater than 30 minutes. This is only logged, no
action is taken.
Fill time is less than 2 minutes. This is only logged, no
action is taken.
N/A
N/A
N/A
Controller lost one of its setup tables
™
Bad ID from Palm
N/A
Service person entered a manual command on control
board to indicate "OFF" on display.
N/A
N/A
N/A
Return to Standard Time
Daylight Savings
Washer lid switch must be detected as open before it is
allowed to run another wash cycle. The washer displays
=OFF= on the display until the service routine is run. See
product Tech Sheet or Service Manual/Job Aid for Service
Routine Procedure. Possible defective lid switch.
handheld
80
Advertisement
Table of Contents
