Table of Contents
Advertisement
Data exchange between PDA & Machine
Using the Send Setup Command (continued)
Using the Get Audit Command
4.
When the operation is complete, tap on Back to
return to the Select a command menu.
Note:
The Management Software will not recognize
the setup data you assigned to the machine until you
have taken an audit and performed a HotSync
operation, to download it back to your PC.
The Get Audit command allows you to track vend
cycles for each machine. Audit data is then uploaded
from the PDA to the PC, containing the Management
Software, for analysis.
1.
Aim the handheld at the machine's receiver.
2.
Tap on Get Audit , located on the Select a
command screen on the PDA.
3.
When the Audit is complete, the following screen
appears. Tap on Back to return to the Select a
command screen.
Important:
If all items on the Get Audit screen are checked, then
the operation was a success. If some items are not
checked, then the communication has failed. In the
event of a failed audit, tap the Back button, check
your aim of the PDA in relation to the control panel,
and perform steps 1-3 again.
®
44
Advertisement
Table of Contents
