Transport - Westfalia 80 02 22 Instruction Manual

45° Cut
1. Attach the 45° Limit Stop (17) on the
angle ruler and position the square or
rectangular tile on the working table.
2. When cutting the tile, make sure the
cutting wheel runs up to the end.
3.
Angle Cuts
1. Adjust the angle ruler (8) to the desired
angle and place the tile on the working
table. Secure the tile with the lateral stop
on the angle ruler (10).
2. When cutting the tile, make sure the
cutting wheel runs up to the end.

Transport

1. For carrying or transport, move the
sliding block up to the end.
2. Fix the angle ruler and fold down the
legs of the stand. Retighten the locking
screws (16.
3. Carry the tile cutter as shown in the
figure.
Using
10