Section Iv: Operating Instructions; Pre-Test Installation And Setup - ETI PI-800 Instruction Manual

Electrical Test Instruments PI-800 and PI-1600
Section IV - Operating Instructions
==============================================================================
PRE-TEST INSTALLATION AND SET-UP
1. The following components of the test set should be available and in good
condition:
a) PI-800 Main Unit
b) PI-AUX Booster Unit (If required for PI-1600)
c) MAC-21 Remote
d) Stab set or cables to match breaker to be tested
e) Input power plugs and cables
f) Input ground lead
g) Contact lead set (If applicable)
h) Remote initiate cable (optional)
2. Additional requirements for testing are as follows:
a) Breakers to be tested
b) Manufacturers' curve data
c) Test log and/or report forms (See examples at end of section)
d) Basic hand tools (wrench, screwdriver, etc.)
e) Safety equipment (safety glasses, gloves, etc.)
f) Reliable and sufficient power source
g) Clean, spacious, and well-lit work area.
3. The voltage selector must be set to match input voltage.
4. Calculate KVA requirements for the source per manufacturer's manual.
5. Remove lids from front and rear of all units.
6. For PI-1600, place PI-800 on top of PI-AUX Boost Unit, plug power and
control cables into jacks on PI-800. Connect inner output terminals
with M-D175 connection bars per diagram. Verify proper vertical align-
ment before tightening and secure latches.
7. Attach appropriate bus interconnectors or cables for desired output cur-
rent mode per diagram. Make sure all connection surfaces are clean and
all bolts are tight.
==============================================================================
Copyright(C) 1994-2003
SECTION IV
OPERATING INSTRUCTIONS
Electrical Test Instruments, Inc. All Rights Reserved