Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for ETI Dry-Well 3101
Summary of Contents for ETI Dry-Well 3101
- Page 1 3101 Dry-Well heat/cool source calibrator User Manual order code: 271-401...
-
Page 3: Table Of Contents
CONTENTS Introduction safety parts & control power lead power switch stand dry-well temperature controller operation temperature setting probe testing maintenance care of the 3101 Dry-Well warranty specification... -
Page 4: Introduction
For optimum accuracy and UKAS traceability use an ETI Reference Thermometer or similar to make comparison measurements. -
Page 5: Parts & Control
several minutes after switching off. DO NOT switch off at temperatures above 100 °C. Allow to cool before storage. Care must be taken when removing probes and inserts from the unit. If the unit is set at a high temperature the inserts will be very hot and could cause burns to the hands. -
Page 6: Stand
A factory set value will be entered at the time of certification. The shift value should only be adjusted if the unit is being monitored by an ETI Reference Thermometer or similar. All other functions of the controller have been factory set and locked to... -
Page 7: Operation
For optimum comparison accuracy use a high precision ETI Reference Thermometer or similar. If probes with a large mass are inserted into the dry-well holes the unit... -
Page 8: Maintenance
This instrument carries a one-year guarantee against defects in either components or workmanship. During this period, products that prove to be defective will, at the discretion of ETI, be either repaired or replaced without charge. The product guarantee does not cover damage caused by fair wear and tear, abnormal storage conditions, incorrect use, accidental misuse, abuse, neglect, misapplication or modification. -
Page 9: Specification
SPECIFICATION temperature range -10 to 110 °C (at 20 °C ambient) resolution 0.1 °C accuracy -10 to 99.9 °C ±0.5 °C 100 to 110 °C ±1 °C holes greater than 6.35 mm ±2.0 °C stability ±0.5 °C heating times ambient to 100 °C after 10 minutes stabilisation 5 minutes cooling times... - Page 10 INSTRUMENT RECORD CARD 3101 Dry-Well order code 271-401 Serial No. _____________________________________________________ Calibrated by ________________________Date _____________________ This instrument has been checked or calibrated against reference instrument(s) calibrated by a UKAS Accredited Calibration Laboratory at -10 °C, 0 °C and 100 °C. To BS EN 60584 manufactured by Electronic Temperature Instruments Ltd...
Need help?
Do you have a question about the Dry-Well 3101 and is the answer not in the manual?
Questions and answers