Performance Series
Programming the System
If you have not selected the mode of operation (Pump or Island) do so now! See System
Mode Selection.
Programming State
1
2
4
5
7
8
MENU
0
Figure 11. D-2400 Keypad
All Station Selectors ship from the factory with a default ID number of 15. It is important to
connect and power up each new Station Selector, ONE STATION SELECTOR AT A TIME,
when installing a new system. Doing this allows you to change the ID number to a lower
value (start at 1) and avoid the erratic behavior caused by multiple Station Selectors sharing
the same ID number.
To program the Performance Series Intercom System, it is
necessary to put the system in the programming state. From this
state, the entire system is configured and all memorized parameters
are adjusted.
To enter the programming state, simultaneously:
Press and hold the STD BY key.
Enter the numeric code: 97531.
The display shows:
3
6
The Parameter #, Parameter Name/Value, and Parameter Value
fields are as shown below.
T
9
A
L
K
SP-389C
The "_ " indicates cursor position. To move the cursor from one
field to another, use the Left Arrow and Right Arrow keys.
To input data at the cursor position, do one of the following:
•
Use the Up Arrow and Down Arrow keys to scroll to desired
value.
•
Use the 1, 2, 3, 4, 5, 6, 7, 8, 9, 0/Menu keys.
The STD BY key clears a field to a default value (space for text or
the default value).
The HOLD key shifts case for text data.
The ALL CALL key exits from the programming state and enters
the Off Line mode.
!
Important
!
01:Selector ID #
{01}
Parameter
Parameter #
Name/Value
↓
01:Selector ID #
{01}
Important
11
Programming the System
↓
← Parameter Value