I/O Card And Noise Reduction Module Installation; I/O Card Installation - 3M 2470 Installation Instructions Manual

Performance series
Hide thumbs Also See for 2470:
Table of Contents

Advertisement

I/O Board and Noise Reduction Module
Installation

I/O Card and Noise Reduction Module Installation

I/O Card Installation

Figure 2. I/O Card Installation
Be sure the system is powered off!
1. Remove 4 screws on each side of the Communications
Controller cover.
2. Remove cover.
Note: Insert I/O cards beginning from connector J5. Add
additional I/O cards sequentially (J6, J7, etc.).
3. Remove slot cover and mounting screw. Refer to Figure 2.
4. Remove all terminal blocks from edge of I/O card.
5. Insert I/O card into I/O connector by pressing gently into
place.
6. Use slot cover mounting screw to secure I/O card to
chassis.
7. Insert terminal blocks into I/O card station ports.
8. Repeat until all I/O cards are installed.
9. Replace cover and 8 screws.
A larger power supply must be used if more than four (4).
I/O cards are installed. Use D2470-20 power supply Part
Number 78-8117-4153-3 when more than four (4) I/O cards
are installed.
After the larger power supply is installed, Remove the
following Warning label:
Do not add any I/O cards to these slots
unless power supply output rating exceeds 4
Amps. See installation instructions for
If adding additional I/O cards after initial installation, you must re-
program parameter 03, "max stations."
2
Performance Series
!
Important
WARNING
details.
Note

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2475

Table of Contents