Page 1
Wired Intercom System Performance Series Models 2470 and 2475 Operating Instructions...
Page 2
This device must accept any interference received including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 3M (IPC) 2002. All rights reserved. Call (800) 328-0033...
Operating Keypad ....................3 Multiple Station Selectors..................3 Setting Volume ......................3 Using the Performance Series Intercom............ 4 One Call Station Calling Station Selector..............4 More Than One Call Station Calling Station Selector ..........5 Using the Hold Feature .................... 5 Calling From Station Selector to Call Station............
Performance Series System Description System Description The Performance Series Intercom System (Model 2470 Introduction Communications Controller) provides two-way audio communications between a keypad interface (called a Model 2475 Station Selector) and several remote Call Stations. It is intended for use in service stations, convenience stores, and other applications.
System Description Performance Series Hold Feature The Hold feature allows an attendant to momentarily disconnect from a call, greet a newer call, and return to the previous call. Paging Feature The Page feature allows an attendant at one Station Selector to communicate with another attendant at a second Station Selector.
Performance Series System Description Operating Keypad Operating keys are described below. TALK This key controls talk/listen communications. User presses TALK button to cancel the alert tone and to transmit outbound audio. STD BY This key controls station connection. User presses STD BY (Standby) button to cancel a Call Station or Station Selector connection.
Using the Performance Series Intercom Performance Series Using the Performance Series Intercom One Call Station Calling Station Selector Customer presses “Push for Service” button at Call Station. Station Selector beeps and displays: • Q=01 indicating there is one call in the queue waiting to...
Performance Series Using the Performance Series Intercom More Than One Call Station A maximum of 24 Call Stations can call the Station Selector. The system stores the calls in a queue (list) in the order received. Q in Calling Station Selector the display shows the number of calls in the queue.
Using the Performance Series Intercom Performance Series Press the HOLD key again. The display shows HOLD = 01 and LIS. The second call is : HOLD=01:LIS still on hold and the Station Selector is connected to the first S=12: PUMP # 12 caller.
Performance Series Using the Performance Series Intercom Press a key to select a starting number. Use the Left/Right Arrow keys to find the desired Call Station. 3. Proceed as described under Steps 2 through 4 under the previous section One Call Station Calling Station Selector.
Using the Performance Series Intercom Performance Series Paging to another Station Selector There are two ways to page from one Station Selector to another Station Selector: • Enter a specific Station Selector number. • Use directory assistance. To page by entering a Station Selector number: 1.
Audio level is set to the mid level of 8. Error Messages The system displays one error message: NO COMMUNICATION. If this message occurs, call your 3M authorized dealer or call ! E R R O R ! 3M Technical Support at 800-328-0033.