Figure 4-6 - Web Site For Firmware Update Status - Flashing; Figure 4-7 - Web Site For Firmware Update Status - Flashed, Waiting For Activation - Siemens EN100 Installation And Activation

Figure 4-6 - Web site for firmware update status - flashing

9. You need to press the "Refresh upload statistics" Button to know if the flashing is finished. After
successful flashing the activation link "Now restart EN100 and wait 60 seconds..." is visible in the
bottom of the page. For further actions please read chapter 4.3.
For firmware activation please see chapter 4.2.2.2.
Figure 4-7 - Web site for firmware update status – flashed, waiting for activation
NOTE: The flashing will be finished in every case independent if the flashing supervision time exceeds. So
the module firmware will be valid after flashing. Caused by the exceeded flashing time there are error
messages in the system log (refer chapter 5.2).
NOTE: It is always possible to repeat uploading files before resetting and activation firmware.
SCF 11/2008 V08.10 Page 12 of 29