Advertisement
MOUNT RACK TO YOUR VEHICLE
Unlock and remove the End Caps from the Strap-on
(
)
A
Feet. Un-hook/un-clip the Rubber Straps. Place the
Rack Assembly over the Vehicle's Top Rails in the
desired front to back position.
Re-hook/Re-clip the Rubber Straps making sure
they run under and around the Vehicles Top Rails
and adjust each Strap-on Foot so that Vehicle's
Top Rail sits centered on the Strap-on Foot.
Each End Cap comes with a Hex Key attachment.
Using the Hex Key loosely fasten the Allen Bolts
indicated by the arrow.
To complete your installation, center the Rack from left to right using a tape measure. Ensure that the
(
)
B
Strap-on Feet are sitting all the way in on the Adapter Plates. Fasten all the M8 Nyloc Nuts securing the
Adapter Plates to the Rack and the Allen Bolts on the Strap-on Feet.
TAKE A TRIP
(
)
After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where needed.
A
You'll find a small amount of settling has happened.
Go on many more adventures, periodically checking all nuts, bolts, screws and fittings.
Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle
manufacturer's recommendations.
REV_A01
3
Advertisement
