Installation Diagram; Dip Switch Settings; Bose Adaptor; Adjusting The Gain - Crux SOOGM-15 Quick Start Manual

NOTES:
- A relay may be needed for radios that require more than 3 amps power.
See connection diagram on the right. An instance when a relay is needed is when the
radio power cuts on and off.
SETTING THE AFTERMARKET RADIO BRAND
With the key in the off position, turn the rotary radio selector to the corresponding aftermarket radio.
USING THE BLUE/YELLOW SWC WIRE
If a Kenwood or JVC radio is used, you must connect the BLUE/YELLOW SWC wire of the GM-16 harness to the
BLUE/YELLOW SWC wire of the aftermarket radio harness. Follow the radio selector settings above.
If the vehicle is equipped with a factory Bose system, use the 8-pin Bose
adaptor that is included. Plug in the Bose adaptor between the two 8-pin
harness connectors. (The Bose adaptor allows for the radio to match the
Bose amplifier's level)
High Gain (non-Bose)
- Press OnStar button and listen for, "OnStar Ready", turn Dial knob to 9, adjust volume to desired level,
wait for 4 seconds then press OnStar button, wait for "Thank you, Goodbye" confirmation.
- Turn Dial Knob back to corresponding Aftermarket radio setting. The interface is defaulted to Low-Gain
(Bose Systems)
2/2 rev.020716