Sony CCMA-2DAR Connection Manual page 2

Microscope Connection Guide for the CCMA-2DAR Adapter
Connecting to the Carl Zeiss Meditec LUMERA-700
Adjusting
the Viewing Angle Position
While viewing the monitor, adjust
3
the rotation by using a hexagonal
wrench to loosen the screw
securing the camera adapter and
camera head, and then tighten the
screw with the hexagonal wrench
to secure them again.
Focus wrong
Focus correct
While viewing the chart displayed on the monitor,
5
adjust the focus by pushing (and holding) the
NEAR and FAR buttons on the controller.
For the controller cable, slide the joint and pull it
1
directly out to remove it.
MK20363V1OHB19MAY
and the MCC-1000MD
3
Operating Procedure
1
Use the hexagonal wrench to adjust the up, down, left, and right positions so
4
that your chart appears in the center of the monitor.
TIPS
If the remote control does not operate
because the battery has run out, you
can use the adapter's FOCUS dial to
adjust the focus (For emergency
purposes only; be careful not to touch
the clean field.)
6
Advice on Cable Disconnection
For the camera cable, pull it out while turning the
2
ring of the joint.
While looking through the
microscope's ocular lens, centrally
place your printout of the chart for
adjusting the viewing angle
position. The recommended
working distance is around 30 cm.
If iris adjustment is required, turn
the dial to adjust the focus (F2.8 is
OK by default).
For the camera head, turn the main unit to
3
remove/attach it (make sure to disconnect the
camera cable).
Support call:
Email:
Turn on the camera power and
2
display the chart on the monitor.
Connection setup is complete
7
(finished state).