Miele WCG 360 Operating Instructions Manual page 62

Problem solving guide
Fault message at the end of a programme
Problem

Check filter + jet
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor control.
62
Cause and remedy
The pumps are soiled.
 Clean the pumps as described in "Problem solving
guide – Opening the door in the event of a blocked
drain outlet and/or power failure".
 Restart the programme after cleaning.
The nozzle in the top of the door ring is blocked with
fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Restart the programme after cleaning.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used but with reduced functionality.