Fault Message At The End Of A Programme - Miele WCG 360 Operating Instructions Manual

Fault message at the end of a programme

Problem

Check dosage

Hygiene info: run a
programme at min.
75 °C or the "Clean
machine" pro-
gramme

Align the washing
machine
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor control.
Cause and remedy
Excessive foam has built up during washing.
 Use less detergent next time. Follow the manufac-
turer's instructions on dosage given on the pack-
aging.
When washing, a wash programme using a temperat-
ure above 60 °C has not been run for a long time.
 Turn the programme selector to Further pro-
grammes/.
 Touch the  sensor controls until
appears in the display.
 Touch the OK sensor control.
The following appears in the display:
 Touch the OK sensor control.
 Run the
Clean machine
chine cleaner or a universal powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
The Pre-ironing extra option which runs at the end of
the programme could not be carried out properly.
 Check whether the washing machine is aligned
correctly (see "Installation – Levelling the ma-
chine").
 Check whether the maximum drain height of 1 m
has been exceeded.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used, but without the Pre-ironing extra op-
tion.
Problem solving guide
Clean machine
programme using Miele ma-
Maintenance
61